♦ Wind Turbine and Load Adaptive Impedance Matching, maximize energy utilization.
There is internal resistance in Wind generators, batteries and loads. According to impedance matching principle, only when input impedance equals to output impedance, power utilization is maximal, get the maximum power.
♦ Protect wind generator from over-revolution speed, over-voltage and over-current
Max revolution speed, max voltage and max current of wind generator could be set. Once the actual revolution speed, voltage or current over the set ones, PWM intelligent unloading will start automatically. That protect wind generator.
♦ Intelligent limiting of batteries max current
Batteries maximum capacity could be set through this controller. According to the set maximum capacity, controller could calculate the maximum charging current. Then batteries will be protected.
♦ Two DC output, each one has 9 output modes
♦ Function of manual brake
♦ Wind charging manual switch
♦ Solar charging manual switch
♦ DC output manual switch
♦ BOOST and BUCK function
The software is easy to operate need not to be installed. You can browse and set parameters on PC through the software. You can download the software from official website. http://www.03ne.com/en_version/ziliao/
Browsing interface on PC:
When wind generator voltage is lower than battery, controller starts boost module automatically, then wind generator voltage is increased to the charging voltage, this is boost charging. When wind generator voltage is higher than battery, in order to acquire max power, buck module of controller will be started, this is buck charging.
Loads lower the revolution speed of wind generator, when it is breeze. That decreases the output power of wind generator. Through max current tracking (MCT) and max power point tracking (MPPT), output of wind generator is stabilized at the max balance of wind energy utilization. Combine with boost and buck function, wind energy utilization is increased.
Tel：+86 152 5627 3957
Fax：0086 551 6573 2123
Wechat：0086 152 5627 3957
（dimensional code on the left）